Talked to several gunsmiths about the project and had my parts list in hand. Found this one from Dennis Olson listed on the Fort Worth Tx Cabela's website for pretty much the cost of the parts. Called Dennis to have him look at it and he verified that it was his work (Cabelas did not have any supporting documentation and would not take the stock off the rifle). Just picked it up yesterday and I am happy with it overall. I am going to send it back to Dennis for a once over, a few tweeks and touch ups.

I haven't given it a good going over yet but here are the details I have.

Winchester Model 70 G series
Douglas special order CM barrel at 23 inches
Modified bolt handle - pear shaped
Modified bolt release
Original trigger but has been worked, don't know lbs but it is clean and crisp
Dennis Olson quarter rib
Barrel band - uncertain of make
NECG Front sight
English Walnut stock - LOP 14 inches
Leupold 1.5 x 5 VXIII with a heavy duplex
Weighs 9.5 lbs with three down, no sling.

Here are the pictures I copied from the Cabela's website. They are better than anything I could pull off. Unfortunately the picture that shows the whole rifle was not saved properly.

[Linked Image]
[Linked Image]
[Linked Image]
[Linked Image]
[Linked Image]
[Linked Image]
[img:center]http://i848.photobucket.com/albums/ab43/scwjones/404-13.png[/img]

Last edited by SWJ; 07/03/15.