I may consider reaming the lube grooves out of mine; it shoots fine but they tend to hang up when ejecting from the mold. It had square bottom grooves that were hanging up pretty bad, I turned them to round bottom but it still hangs up a little. Don't need them for PC anyway.
I've switched to using my 105gr modified hollow point 100% for "normal" loads, but that 125gr Mihec hollow point makes a great subsonic/suppressed bullet. I don't remember if I modified the pins; they are a straight sided cone but still deep. Cast from wheel weights, they give perfect expansion at 900-1000 fps. Real good load for charging bunnies and squirrels, long as you don't plan to eat them.
