Not sure if they inlet the stock for a Sako 85...
Just got back from the range using some 165gr Accubonds over a max charge of Reloader 15. 5 shot group was 1.1 inches with a bit of vertical stringing. I could probably do better when it gets a bit cooler as there was a very slight mirage from the heat. I could also concentrate more on my bench rest technique to improve consistency. These loads Chrono'd at an average 2680 fps. I had switched out the scope to VX3 2.5 -8x from the older 2.5-8x that was in the photo in this post. The Decelerator pad although only 1/2 inch made this rifle much more pleasant to shoot than my Model 70 stainless .308 in a regular McMillan Stock with 1 inch standard recoil pad (shooting same loads). My rifle shot well with the original factory stock, but the handling is much nicer with the lighter McMillan (made with Edge Technology).
Ed
