Originally Posted by Coyote_Hunter
Originally Posted by JeffyD
Originally Posted by 444Matt
I found a prefit pachmayr 01736 by doing a little google search. I think I will try that out.


Yep, that's the right model number for the pre-fit Decelerator pad. I put one on my "boat-paddle" stock, and it was a perfect, flush fit. Only problem was, I needed slightly longer screws. I was lucky enough to find a pair in my toolbox that I cut to length.

Jeff


Were the mounting holes correctly spaced?


The holes were correctly spaced, but the lower stock hole had to be deepened a little bit to snug the pad down flush against the stock, no big deal. After that, the fit all-around was as perfect as if it came from the factory.

Jeff

"No good deed shall go unpunished!"