Originally Posted by MallardAddict
Not sure how i missed this. Here is mine. Its a lightly modded MKIII Browning. Bobbed hammer, trigger and action work, magazine disconnect removed, VZ grips and XS sights.

Eventually I will get the safety swapped to a bit wider paddle, get front and back straps stippled them probably have it sandblasted and coated.

Also for some reason the Mecgar 15rd mags won't drop out but the factory 10rd's do. Any advice is appreciated.

[Linked Image]
Mec Gar OEM's Browning Hi Power mags, so those are factory mags.

I see the pin for the mag safety is missing, so it's not the magazine safety.

Grip makers will sometimes cut their inlets too deep and the inlet part of the grip panel may be bearing against the magazine. Try loosening the grip panels and then see if the drop free. If they do, ten you just need to take a sanding block to the inlet portion of the grip panel and lower it a bit until they drop free with the grip screws tight. Let me know how it goes.

Last edited by GunGeek; 06/18/14.