OK I need some help.
I am getting ready to order some slug molds for this rifle 45-90 WCF)
I am on a group buy for a MiHec 45-70 hollow base 392 gr. and with a plain base pin 415gr solid. I may make a Gas Check pin for this after I get the mold. The buy has been going on for 2 1/2 years so I am not holding my breath on this one.
I am looking at Accurate molds and found a 46-325CG and a 46-500BG both with gas checks. I will order them with a .462 dia. and squish them down to a possible .460 with my lubber.
I have asked Turnbull for the bore dia. of the actual rifle and they have not responded as of yet so I will hold of on my sizing Die for now.
Am I going in the right direction or is there something that I should be looking into.
Any advise would be appreciated.
Last edited by funshooter; 09/07/14.
