Home Forums Hunting & Shooting Handguns 41 magnum

Ron...let me know if the 300s I sent you will fit in your handguns. One of the ones I had won't fit in the handguns but work fine in the Marlin.

Tried out some test loads on Tuesday. One was the Accurate Molds 41-250F and the other the 250L. I designed the F as it is a longer version of the V I requested. The L is for leverguns and is a gas checked boolit. Both boolits are cast in the same mold. They were loaded with 22.0 grains of H110 which should put them right at 1400 fps from a 5.5" barrel.

Range was 20 yards standing. Fired two 5 round groups out of the Freedom Arms 654 6". These loads will stand the gun right up.








Then fired five more rounds into each of the targets..



Groups aren't the best but every shot went where called. I fired three rounds of the 250F out of a 6.5" Blackhawk and called it quits...these loads are a little much for the small BH grips. Think I'll stick with the 220 Keith bullets with that one...

Bob