I have the following for sale, all prices include shipping to the lower 48 or to somewhere with normal shipping rates:
Remington 700 barrel from a 1970's model Varmint Special rifle. High Gloss finish. Chambered for .308 Winchester. Not a mark on the outside, and bore looks great. Bought it from a consignment rack, supposedly only shot a few times by the original owner. Based on the near pristine shape of the gun, I believe it. Would make a great barrel to replace a shot-out Varmint Special rifle or a heavy barreled build. Barrel only. ($100)
Remington 700 LSS Short Action BDL style stock, grey laminate, never been bedded, has been hunted, but the few scratches are only indents in the finish, nothing deep. It's in really nice shape, recoil pad is good too, not sticky at all. ($150)
Remington 700 CDL Long Action BDL style stock, walnut, has been bedded around the tang and the front of the action/first few inches of barrel. Not the prettiest bedding job, but did shoot well afterwards. Speed bumps have been sanded out/refinished. ($75)
Remington 722 Short Action Stock with Bottom Metal, Action Screws, Magazine and Spring, and Trigger. Stock is in well used shape, probably been hunted for a few decades. No bedding. The first few (2-3?) inches of forend have been chopped off, and someone installed a recoil pad and didn't do a great job. If someone wants just the trigger or some other parts, I can split it up. ($50 shipped)
Remington 870 youth laminate stocks from a 20 gauge. Just the wood/recoil pad, no hardware. This should bolt up to a full size 870 20 gauge, for a kid to use, not sure about a 12 gauge... Great shape, a little spot where the thin finish has been rubbed, and two minor nicks. ($40 shipped)
Winchester Extreme Weather takeoff stock. Short Action, sporter barrel contour. Made by Bell and Carlson. I bedded this rifle to a featherweight rifle, had quite a bit of free float. A sporter barrel contour would be just right I think. I ground the bedding out forward from the bedding block, it looks a bit rough
. Once it's rebedded (including a few inches of barrel) the only mark that will be visible is a nick from a dremel on that portion of stock just below the chambering markings on the barrel. It wont affect function or strength. I have pictures as requested. ($120 shipped)
If interested, please send me a PM, make an offer if something seems unrealistic. I have pictures, can email them if requested. Thanks!
