Holster #1- $100
SPFSunday Slicker, RH-
Built for 4in N frame S&W
12oz veg-tanned leather
Water based Cordovan dye
2in belt loop, ideal for thick 1 3/4in pants/gun belt
Oakleaf pattern tooling
Sinew hand-stitched
Equipped with internal tension welt, but will add hammer thong or snap at buyer's request.
Holster #2- $85
Brushpopper Special RH(my version)-
Built for 5 1/2in Ruger Single Six (will also snuggly fit Colt SAA and clones.)
12oz veg-tanned leather
Water based Cordovan dyed belt loop, natural tanned holster
2in belt loop, ideal for thick 1 3/4in pants/gun belt
Floral pattern tooling
Sinew hand-stitched
Independent hammer thong
Built for high and tight carry
This design has been produced by many skilled builders, but I was never comfortable with my mechanical strap and hammer thong being one in the same, so the mechanical strap is permanently affixed to the holster while the hammer thing remains independent.
PayPayl Friends and Family, Zelle, personal check or money order will work, plus actual shipping cost.
Going back through my posts over the years on the singleactions forum you'll find each of these models used extensively, with the tooling and finish almost worn beyond recognition, but still together and functional. I've spend years using these designs in the harshest of hunting/working environments, and though the specific units are brand new, the design and material is time tested. Below are a few photos of these models sporting some wear after more than three years of testing. Sincerest thanks for looking. Cross posted.