|
Joined: Jan 2018
Posts: 2,072
Campfire Regular
|
OP
Campfire Regular
Joined: Jan 2018
Posts: 2,072 |
I see Hornady makes a .308 125gr FMJ bullet. Was wondering how it would work in an AR. Any here have experience with a 125gr bullet in the 308 AR? If so what powder worked in this platform? Need a load that stays under 50,000 PSI.
|
|
|
|
Joined: Nov 2002
Posts: 21,790 Likes: 2
Campfire Ranger
|
Campfire Ranger
Joined: Nov 2002
Posts: 21,790 Likes: 2 |
I have shot the hornady TAP 115 grain Vmax ammo in a 308 AR.
Quite accurate. Wind moves it around past 200 yards.
The 125 should be fine
Never hand loaded anything in 308 except 175 SMKs
God luck
"The Church can and should help modern society by tirelessly insisting that the work of women in the home be recognized and respected by all in its irreplaceable value." Apostolic Exhortation On The Family, Pope John Paul II
|
|
|
|
Joined: Jan 2018
Posts: 2,072
Campfire Regular
|
OP
Campfire Regular
Joined: Jan 2018
Posts: 2,072 |
Was hoping someone had experience with this weight bullet in the AR platform. In a bolt action, many different powders can be used. In the AR type action their are powders in a specific burning rage that function the action safely & properly. Powders like H-4895 & Varget.
|
|
|
|
Joined: Jul 2015
Posts: 14,732 Likes: 2
Campfire Outfitter
|
Campfire Outfitter
Joined: Jul 2015
Posts: 14,732 Likes: 2 |
Just take the powder charge from your 150 or 168 or even 175gr load and seat a 125 instead. Makes a wonderful, accurate, low-recoil load especially with stick powder.
Any of the normal sticks will work - 4895, 4064, Varget, AR Comp, Re-15, N-140, etc.
Ball works too (748, BLC-2, etc), but unless you have a muzzle break they don't seem to be much less recoil due to the rocket effect of their muzzle blast.
Politics is War by Other Means
|
|
|
|
Joined: Sep 2001
Posts: 19,078
Campfire Ranger
|
Campfire Ranger
Joined: Sep 2001
Posts: 19,078 |
With a gas gun, port pressure will have more effect on cycling, than peak pressure.
Most M80 ball ammo uses a 147-150gr bullet and a powder charge around 41-42 gr of powder.
So a powder charge of around 41-42 gr should provide similar gas volume/port pressure.
I'd look into a loading manual and find a load for the 125gr bullet that gives suitable performance at around 41-42 grains of powder. Something with a burn rate similar to RL-7, or RL-10 should get you in the ballpark.
|
|
|
|
Joined: Jan 2008
Posts: 5,179 Likes: 1
Campfire Tracker
|
Campfire Tracker
Joined: Jan 2008
Posts: 5,179 Likes: 1 |
This is what I've found. Warning! Notes: All handloads were fired from a Colt LE901 with a 16-inch barrel. The three-shot groups were fired at 100 yards over a Shooting Chrony Beta Master chronograph 10 feet in front of the muzzle. Winchester cases and Winchester Large Rifle primers were used throughout. The Leupold Mark 4 3.5-10x 40mm scope was set on 10x. (Rifle AR Special Edition - Fall, 2013) Wt. Bullet Powder Charge Velocity
125 NBT TAC 49.0 2908 Warning! Notes: Sun Devil AR, 22-in. barrel. Velocity was measured with an Oehler M35P chronograph at 8 feet from the gun's muzzle. Accuracy is the average of two or more five-shot groups fired from a benchrest.
Wt. Bullet Powder Charge Velocity
125 Sierra H-335 47.0 3016
|
|
|
|
Joined: Jan 2018
Posts: 2,072
Campfire Regular
|
OP
Campfire Regular
Joined: Jan 2018
Posts: 2,072 |
|
|
|
|
280 members (1minute, 1_deuce, 16gage, 17CalFan, 10gaugemag, 16penny, 38 invisible),
1,947
guests, and
1,073
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
Forums81
Topics1,192,859
Posts18,497,167
Members73,979
|
Most Online11,491 Jul 7th, 2023
|
|
|
|