|
|
Joined: Mar 2009
Posts: 117
Campfire Member
|
OP
Campfire Member
Joined: Mar 2009
Posts: 117 |
Can someone give instructions for putting a vertical line on a rear standing leaf that requires a minimum amount of tools and abilities. Thanks.
|
|
|
|
Joined: Oct 2008
Posts: 1,628
Campfire Regular
|
Campfire Regular
Joined: Oct 2008
Posts: 1,628 |
Measure the width of the rear blade and divide it in half. Subtract approximately .010 from that measurement and set and lock your calipers. Now, from the outside to the center, on each side, transpose that distance using a pencil. You should now have a nice .020 line that you can scribe into the blade using a straight edge and scratch awl.
Or, you can mask to the line from each side and paint it using an acrylic artists paint. Pull the tape and you should have a clean little .020 vertical line. Or, scribe it then paint it.
Lock, Stock and Barrel gunworks SLC, Ut USMC 69-73
"This is my rifle, there are many like it but this one is mine. My rifle is my best friend, it is my life."
|
|
|
|
Joined: Feb 2001
Posts: 50,681 Likes: 2
Campfire Kahuna
|
Campfire Kahuna
Joined: Feb 2001
Posts: 50,681 Likes: 2 |
Reminds me of the RCA label with the dog listening to the Gramaphone... "His Master's voice."
The Dude is good!
Malm, that was as neatly described as it can be.
Mark Begich, Joaquin Jackson, and Heller resistance... Three huge reasons to worry about the NRA.
|
|
|
|
Joined: Mar 2009
Posts: 117
Campfire Member
|
OP
Campfire Member
Joined: Mar 2009
Posts: 117 |
I like that response, and it sounds doable, even for me. Thanks.
|
|
|
|
Joined: Jan 2001
Posts: 29,974 Likes: 11
Campfire Ranger
|
Campfire Ranger
Joined: Jan 2001
Posts: 29,974 Likes: 11 |
Concise and nice. Well said +1.
Last edited by 1minute; 11/21/10.
1Minute
|
|
|
|
544 members (1234, 10gaugeman, 12344mag, 10gaugemag, 17Hunter, 06hunter59, 59 invisible),
18,555
guests, and
1,272
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
Forums81
Topics1,194,961
Posts18,539,694
Members74,052
|
Most Online20,796 04:44 PM
|
|
|
|
|