Dogshooter
How did you put a zero stop on yours. I have two I would love to add them to
It'll strip out.
Kinda like your Mom?
Dogshooter
How did you put a zero stop on yours. I have two I would love to add them to
Zero stop was actually pretty easy, as it's all set-up for one.... you just gotta be a bit creative.
Mark ARs are the same as the CDS underneath.... So there is post for the stop on the scope, and an indention in the bottom of the cap to accept a 1/16" bearing. Here's where you need to be creative, as the indention is intentionally mid-located by Leupold so folks don't just install it themselves, and cheat Leupold outta $75
I simply took a small mill bit in the Dremel and extended that hole clockwise slightly so a small dab of JB Steel putty could adhere to the scuffed aluminum of the cap. I used a small bit of turtle wax on the scope as a release agent, then slipped the cap back over the post and turned it back to zero, GENTLY.
Pull the cap off, trim an excess putty from the race where the stop sits.... and allow to dry. It looks like this when its done. It cost my two clicks off the top, so I have 5.8 MILs total travel.... which is right at 900 with the .260.