Fed 210, 58 gr, 250 gr of hornady or speer, max load and ~2500 depending on your barrel. The same load will drive a swift A-frame about 2600 and is a bit hot, the partition raises pressures and it would be best to back off a grain or so.
I just finalized my moose load this morning at the range, but I'm using RL15. 55gr, Fed210, 225gr TSX, 2675-2700fps and under 1MOA. I've heard good thing about Varget but I haven't tried it yet.
i use Varget in my 35Whelen, 61gr, CCI-250, Rem brass and 250gr barnes X. Hodgdon recommends 50-55gr with a 250gr bullet. My rifle makes hardly 2300fps with 55gr , 61gr makes 2684fps out of a 22" tube. Start low and work up!!!
I went up to 60gr for just under 2600fps with a 250 Hornady with outstanding accuracy. I had some pressure signs and promplty went back down to 58grs. I still get about 2525fps and nothing shot has run off due to losing 75fps.
Hunt hard, kill clean, waste nothing and offer no apologies.
"In rifle work, group size is of some interest...but it is well to remember that a rifleman does not shoot groups, he shoots shots." Jeff Cooper
i used tyo use IMR4320 before Varget came along and top load was also 2525fps. And, yes anything fairly shot did not run off. I started varget with the start load 2100fps went slowly to top load (55gr) for 2300fps. i knew i was not getting enough pressure because of speed or lack there of,so i continued slowly until I got eradic ignition at 63gr, then backed off to 61gr and have been using this load for 10 yrs with no problems.