Hello. I've a question about the best way to level a scope. I use a one piece picatinny rail on my bolt guns with Warne QD rings and 2 Innovative Technologies magnetic scope levels. I put 1 on my rail, if aluminum I use a tight rubber band from end to end & around the stock, and 1 on my elevation turret without the cap. When my rail is square & level I use the 1 on the turret to level my scope then tighten rings while watching the level for a change. To me the cross hair is level but some of my friends pick up the gun & say the scope needs to roll either R or L which brings me to a big question. If your center POI is the same at 400 yards, vertically, as it is at 100 yards, doesn't that indicate your scope is mounted square with the bore? I would love to hear any suggestions on mounting a scope. Thank you very much, Jim D
