I'm wondering if I'm doing it wrong. Or better yet, if I could be reloading more right.
When I measure OAL I measure from the tip of the bullet. Accubonds and BTs aren't much of an issue because they're all really close to each other in length. Spin the seater up or down, measure, bingo.
Partitions and VLDs aren't quite so uniform. I sort through bullets to find one of predetermined length and use it as the representative bullet, so to speak. Spin the seater, find the right length, bingo.
But I've read about measuring from the ogive, since that doesn't change, while the tip can be off for a variety of reasons. So the question is, how many of you measure from the ogive, and how do you do it? And who just measures a bullet and calls it good?
P
I just measure to the bullet tip and call it good. The other chit is way over rated..
.
