I am thinking about rebarreling a Model 70 and putting it in an after market stock, probably a McMillan. There are some choices available to me if I do this.

1. I can use either a pre 64 and a 2009 featherweight for the action. Would one be better than the other? I kind of hate to disassemble a pre 64 but the result of building another one would be important too.

2. If I happen to get a McMillan that takes the two piece floor plate, is it a big deal to get the adapter that allows the one piece to be used? Are there any problems inherent to using the spacer?

Any suggestions would be appreciated.



Hard times create strong men. Strong men create good times.
Good times create weak men. And, weak men create hard times.