Mac, thanks for the info/correction on the boiling point of tin.

Originally Posted by crossfireoops
....e.g. a LARGER, heavier Ladle for LARGER, heavier bullets...That little one pictured just doesn't hold enough alloy to do anything BUT give you the results you're getting,it's damned near EMPTY by the time the mold's full.
Cheers,
GTC


Being the proud owner of both a Cameron Dumpster Ladle and a Cameron Double Dumpster Ladle (for two cavity molds) I can attest to the consistency of bullet weight and mold fill-out when pouring into large caliber molds. They provide sufficient pressure and alloy temperature (due to higher thermal mass) to fully fill out the large cavities.

Ed

"Not in an open forum, where truth has less value than opinions, where all opinions are equally welcome regardless of their origins, rationale, inanity, or truth, where opinions are neither of equal value nor decisive." Ken Howell