Seems I am missing something. I was under the impression that factory brass was always on the minimum spec for sizing so that it would fit 99% of the rifles chambered for it.
Your right but Nosler has brought it to a new level with there loaded ammo, minimum specs are one thing but shoulders set back farther than minimum spec causes the problem, I have measured some that had lite primer strikes a few years ago from a customer and the shoulders were set back a lot compared to winchester, remington and caused a headspaces problem. I bet if the op was to measure he would find the problem. That's why I don't buy or sell Nosler ammo. The customer that had that problem with Nosler ammo went back to other manufacturers ammo and never had a misfire or lite primer strike again.
