Anyone tried the new stock on a older Predator?
That was my plan for today, but I can't get the AI version apart. I mean, I probably could, but I'm waiting on the missing tool and slave pin. The instruction manual doesn't explain it, I had to download the online version.
In short, look at the pic boomer posted.
You have to drive the magazine release pin out with a 1/8" punch and make sure the spring don't go flying to Mars. That is the only was to access the rear screw.
There is a little plastic tool and a shorter pin. You put the release lever in tool, along with the spring and the slave pin. You then slide it back till the release lever is seated and the hole lined up. You then tap back in the pin you previously tapped out and it pushes out the slave pin on the other side.
I'll see how it goes when I get the sheit install the lever from Ruger, they are mailing it to me.
So in short, if you want to take this thing apart you need an allen wrench, punch, plastic tool and a slave pin.
