Home Forums Gear Hunting Trucks and Four-Wheel Drives Low Fluid Tacoma Transmission

A750E AUTOMATIC TRANSMISSION – AUTOMATIC TRANSMISSION FLUID
AUTOMATIC TRANSMISSION FLUID
ADJUSTMENT
1. BEFORE FILLING TRANSMISSION
• This transmission requires Toyota Genuine ATF WS.
• It is necessary to refill the transmission with the
correct amount of fluid.
• The vehicle must remain level while adjusting the
transmission fluid level.
• On vehicles equipped with active suspension, turn the
suspension control switch OFF if it is necessary to jack up the vehicle with the engine running.
2. TRANSMISSION PAN FILL
(a) Remove the refill plug and overflow plug.
AT–135




(b) Fill the transmission through the refill hole until fluid begins to trickle out of the overflow tube.
(c) Reinstall the overflow plug.
3. TRANSMISSION FILL
(a) Fill the transmission with the correct amount of fluid as listed in the table below.
(b) Reinstall the refill plug to avoid fluid splash.
HINT:
If you cannot add the listed amount of fluid, do the following:
Specified Fluid Level Overflow Tube
C113723E01

Repair
Fill Amount
Transmission pan and drain plug removal
1.3 L (1.37 US qts, 1.14 lmp qts)
Transmission valve body removal
3.9 L (4.12 US qts, 3.43 lmp qts)
Torque converter removal
5.3 L (5.60 US qts, 4.66 lmp qts)
Entire transmission assembly
5.3 L (5.60 US qts, 4.66 lmp qts)
AT

CG
DLC3
TC
G029469E01

AT
AT–136
A750E AUTOMATIC TRANSMISSION – AUTOMATIC TRANSMISSION FLUID
• Install the refill plug.
• Allow the engine to idle with the air conditioning
OFF.
• Move the shift lever through entire gear range to
circulate fluid.
• Wait for 30 seconds with the engine idling.
• Stop the engine.
• Remove the refill plug and add fluid.
• Reinstall the refill plug.