I think, if I had it ALL to do over again, I'd do it the same way. That way was to have Mike Bellm rework my hammers by heliarcing them to add metal to the spur shank & install his lightweight extensions.
Actually preferred this to the Encore retrofit. If you send your gun to T/C and they find a trigger job has been done, they'll yank all your parts and put you right back to square one. Been there & done that.
The new T/C hammer is ok but I like my Bellm stuff better.
WHATEVER YOU DO...DO NOT BUY OR EVEN SCREW A STEEL EXTENSION ONTO YOUR HAMMER SPUR !!!!!
If you so much as even tighten it onto it and change your mind as I did, the spur will break sooner or later. I had to pull the hammer back by sticking my finger on the face between the frame for two seasons. If you go with the aluminum Bellm extension it'll be smoooooooth sailing for you.
www.bellmtcs.com
