1. They won't go in straight (I use my forefinger as a concentricity tool and pop--literally **POP**--them back vertical.)
2. Load to 3.600" and they have little to no neck tension. Case mouth is not past ogive as best as I can tell. (I checked the math using a point on the bullet bearing surface where the case mouth could safely be and easily get to my COL 3.600" with room to spare.)
.365" case mouth ID
Lee seating die (backed 1/2 turn off from mouth contact)
Did not resize or uniform mouths (M die, trim, etc.) but that's nothing new
I gotta go to bed. I'm driving myself nuts.
