Just did some sanding and contouring of certain areas
Then a tru oil finish
Soften the sharp angle early 70,s lines and some selective removal in certain areas.
Stuck a .705 aftermarket choke on it
Truglo fiber optic bead, sims pad.
Polished the bolt to 2000 grit ,the old jeweling on it was pretty bad.
Detailed stripped down cleaning.
If ya ain't dropped your trigger assembly.
I did mine it looked the the munsters undusted fireplace mantle
Blast it completely out with a good oil based product turn it upside down let it drip for 10 or 15 mins
Repeat a couple of times.
Vids on complete take down and reassembly are out their.
Biggest PITA is getting the bolt finger bar cocking peice and plate assembly out and back in.
It screws right into the bottom of the bolt .
You will see it when ya drop the trigger assembly
Once you break it down and put it back together a couple of times
Its becomes easy.
But the bolt finger bar cocking peice will always be a PITA.
Last edited by renegade50; 07/07/19.
