OK, I get that.
So what are your capabilities with this stuff and what kind of tools do you have? Lathe, etc? Do you have some experience chambering barrels, or is this your first time? Are you the sort of guy who's pretty handy with tools and does quality work, or the other kind? The answers on how to do this depend a lot on what you can do. For example, there's not much point in suggesting how to do it on a lathe if you don't have one. You can do this by hand but it takes some attention to detail and a gentle hand with the reamer.
This barrel isn't nitrided is it? If it is, forget it, you'll most likely ruin both the chamber and the reamer; the nitrided surface layer is too hard. If it's bare stainless or parkerized chromoly you have a much better chance at getting it done.
Last edited by Yondering; 10/14/19.
