Well....not one soul had one. Sako, Beretta, Numrich, assorted gun parts dealers, Sears & Roebuck...nobody. I had to make one myself, or at least try. Straightened out a safety pin and went to work slowly. By the way, the broken Sako spring and the safety pin measured exactly the same in diameter: .025". I lucked out and the replacement worked like a charm. In the photo below is the broken pin on the bottom and the safety pin spring on top....thought I did pretty well. The angle of the photograph doesn't show it, but the curves match up well in the respective springs. The little 90 degree turndown is where it broke. And yes, my original picture in my first post, taken off the internet, was the wrong spring.

[Linked Image from i.postimg.cc]


Last edited by Godogs57; 10/15/19.
You only live once, but...if you do it right, once is enough.