ilikeguns :Had the same gun. I have four question for you. Where are the splits? Do the fired unsized brass go in to the chamber with little effort? Is the brass nickle plated? Do you sizes the whole length of the case? If the splits are at the neck and the fired cases go back into the chamber with little effort than you only need to size the case down to the point where the base of the bullet sits. Its like necksizeing just the upper part of a rifle case neck.. If the splits are are at the neck they need to be annealed or replaced. If the cases are nickle plated just poup-can them as annealing them can make them harder than barrel steel.
