I have not tried the Starline brass yet. I use Remington and Hornady brass. Tried Federal brass, but the primer pockets loosen up pretty quick on them.
One thing to note with Hornady brass, is they have a few different batches/head stamps that have different case weights. Not sure if that makes much difference, but I have 2 different head stamps and keep them separated for two different loads.
Remington brass uses large rifle primers. I have no issues using this brass, works well with my 110 hpbt load.
H322 works well with Hornady 110 hpbts, and Nosler 110 Accubonds. Doing some load dev on 110 Vmax, but getting inconsistent results.
Been testing IMR8208. Getting slightly higher velocities and groups almost as well, but more testing is required.
