Bought me a boyds stock for my b-mag and per boyds was to use existing action screws. I ended up stripping the rear action hole (screw is good) the torque
calls for 40 lbs but I wasn't probably 20 and was only going for 25. What caused it was the screws were to long and it hit against my safety and stripped the hole. There are still a few threads where I was able to snug it up,probably less than 10lbs. I had to put a small washer in under my safety so as to space it for the safety to work right. What thoughts on a easy repair? I was thinking thread tape and JB weld on the screw and snug it up enough to where I know it won't come lose or re thread and a larger screw.
