interesting. At a glance I have no clue how those could chamfer if the cutter is up top like it looks. But still its not well made or machined and probably not top grade steel is my guess.
I suppose after loading for high-power for years and finding most LEE stuff just falls apart after a while I have a different view on their stuff mostly.
The powder measure for 19 though for big sticks of powder is fairly decent. Though plastic junk, it sure has a way of working pretty good.
Don't care for the lock rings on the dies, for me it leaves a lot to be desired as is, but then again I usually pull the oring so it will lock up like it should but needs a nice set screw in the side like normal.
The hand primers... I can't count in memory how many parts they sent me over the years.... though they worked until they would bend or break. Which was fairly often.
