I have a batch of bullets that have been sized and had gas checks applied but not yet lubed. That was done a while ago before I started powder coating.

Figured I would PC them now and it would have to go over the checks. I know you're supposed to coat and then size and apply checks which I will do in the future. Not seeing a big problem here but wanted to check with the cognoscenti just in case there is some gotcha. These are RCBS 250 gr. FP destined for a .38-55 at 1650 fps so not a real high stress load.

Gunnery, gunnery, gunnery.
Hit the target, all else is twaddle!