Bulkie, thanks for the input. Really appreciate. My issue wasn’t extreme and didn’t give me pause that my loads were not safe.
Firing from a bench the factory loads feed and functioned with little effort. My reloads also seeming fed fine but occasionally the lever hung up a 1/4 or 3/8” of a inch from seating against the butt stock. I was at a disadvantage at the bench not giving the sharp lever cocking I would otherwise in a field situation. Pulling the lever up the round seated and shot fine. Was never an extreme situation. I was questioning if this was common. Had an idea as to why it was occurring, was just looking for any tips tricks to avoid the issue And save working the brass too much. The 250-3000 isn’t getting easier to find. Also wondered if others experienced the same problem.
Seems I’ve got it worked out. Thanks again for your thoughts.
