Originally Posted by MontanaMan
Well, I guess everyone has an opinion, but I'd much rather use an SLR than a Superlative; Odin is my next choice, but they can be an issue with some small ID handguards.

As to what to change 1st (w/o an AGB), again, IMO, assuming full weight M-16 BCG, then buffer first, spring 2nd (depending on where you started, I always start with Sprinco standard white or slightly enhanced blue) and gas port size change is last.

Here are some nominal gas port typical sizes.................check yours to see if it's close to something nominal. Scroll down to the 300 BO data.

MM

Typical Gas Port Sizes



Looking at that port size info, my 300 BO is .093",
listed for 16" with pistol gas are:
subsonic suppressed .086", subsonic un-suppressed .067"
supersonic suppressed .059", supersonic un-suppressed .0625"


So, likely to be over gassed, and what might be needed is: heavier buffer, heavier spring or less gas?

"I can't be canceled, because, I don't give a fuuck!"
--- Kid Rock 2022


Holocaust Deniers, the ultimate perverted dipchits: Bristoe, TheRealHawkeye, stophel, Ghostinthemachine, anyone else?