Take a fired 9mm case, weigh the charge you want.
Put it in the case, mark the height, cut it off a bit high.
Solder or brase a 16d nail to the bottom.
Try it as a dipper, weigh the charge.
Grind it down untill it's right.
Really doesn't take long.
If you load 100 at a time of different stuff like I do,
It's an investment.
45 minutes to make a dipper.
Never screw with adjusting a measure again.
Once you check it for the first couple rounds each use.
You know it's not gonna need to be rechecked for the batch.
If your hands are getting like mine, you might want to epoxy
A handlemade from a hatchet split/sander shaped 2x4.
Last edited by Dillonbuck; 07/30/21.
