Hey guys. I’m trying to dial in my dads M77 rifle I inherited. it had an old redfield 3-9 that I took off and put on a new burris. Anyways one of the screws on the ring has the head stripped where I can’t torque it down and I can not find a replacement . I Found the right thread pitch and all, but the screw head was too big to fit into the hole.
Before I buy new rings can you help me identify manufacturer or where I can get the proper screw.
Thank you
https://imgur.com/a/6gYNFiQThey look like Redfields to me.
Their contour was a little different than others.
Id look at Brownells or Ebay for direct replacement screws.
However, I may have some you can have. Gotta look and see. Might have pitched em.
Ideally, somebody makes a torx upgrade. But who knows.
I redid my Ruger factory rings w the newer Torx.
Your old non integral 77 is running non Ruger setup.
