Question for those who have done a few of them:
How do you set the height of the bottom metal relative to the action and how do you set the interface between the front pillar on the bottom metal and the mini-pillar coming out of the recoil lug?
My (amateur) thinking is to bed it so the top of magazine box is just below the action but parallel to it, maybe .010 or maybe a little more, just so the mag box isn't bottoming against the action?
And to shorten the pillar on the mag box so there is a similar gap between the top of the bottom metal's front pillar and the little pillar coming off the recoil lug?
I did a 98 a while back which seemed to turn out fine but the inletting on that stock was already pretty good and on this one I'll more or less have to set it all up myself.
Thanks in advance. Happy for any and all corrections.
