I just went out to the shop. Dug out the inch lb torque wrench and tried to torque the angled screw to 90lb. With the flat head groove screw head that is not going to happen. I did get to 65 inch lb before the bit would not stay in the screw. Then i backed it off and set it by hand as tight as i could, then tested it with the torque wrench. 45inlb. This is where i'll leave it with the flat head screw. If i had a allen head or torx head screw i might try for more inlb. But unless i want to destroy my flat head screw, trying 95inlb is not something i will try again.

Last edited by baltz526; 09/02/11.
The anti American Constitutional party (Democrat). Wants to dismantle your rights, limiting every aspect of your constitutional rights. Death by 1000 cuts is the tactic. Each cut bleeds constitutional rights to control you. Control is the goal.