Here's a Remage project from start to finish. Just finished today so no range report yet.
I started with an old 243 Remington ADL, I called Jim Briggs at Northland Shooters Supply and ordered a 7mm-08 light varmint stainless CBI barrel. (FYI Jim was great to deal with, excellent customer service and very helpful)
The Barrel showed up well packaged.
The doner 700, the Barrel, and a Bell and Carlson Medalist.
First off remove the barreled action, trigger, scope, mounts, ect and put the barreled action in a barrel vice.
I usually put a stud in the forward action hole to keep the action wrench from slipping.
I also use a little masking tape between the action wrench and the action.
A little heat may be necessary to soften the threadlocking compound used by Remington. I just use a propane torch, not enough heat to change the temper of the steel.
[img]http://i92.photobucket.com/albums/l16/jpotter75428/IMG_20140409_192155.jpg[/img][img]http://i92.photobucket.com/albums/l16/jpotter75428/IMG_20140409_192220.jpg[/img]Try not to burn the dog
[img]http://i92.photobucket.com/albums/l16/jpotter75428/IMG_20140409_192630.jpg[/img]After the heat just turn off the action with the wrench, it still takes a bit of effort even with the heat but not too bad.
[img]http://i92.photobucket.com/albums/l16/jpotter75428/IMG_20140409_192749.jpg[/img]