Just looking at a couple of other posts concerning Talley rings and thaught I would post my experience, without side tracking the other threads!

I purchased a set of Talley QD's and when fitted them to the rifle noticed that the dovetail was off centre to the rings by 40thou. I contacted Marshall at Talley (the rings were purchased from there) and he contacted the manufactures and found that the rings are machined with 17 to 20thou offset in the dovetail, each side adding up to a 34 to 40thou offset between the dovetail and scope centre! I then replied to Marshall that this was not acceptable and asked what could be sorted. To this date there has been no reply.

I live in Australia which makes return difficult so I decided to suck it up and re-machine the dovetail and clamp to centre it up, completed this and the fabrication of the dovetail base and installed the scope last night.

Had heard lots of good reviews on the forums regarding Talley, worst luck my experience has not been good.

[Linked Image]