|
|
Joined: Jun 2016
Posts: 274
Campfire Member
|
Campfire Member
Joined: Jun 2016
Posts: 274 |
Do you fellows always cast with one mold or more?
I always use two in rotation, while one is cooling and the sprue hardening I'm filling the other one. That generally seems to keep the mold temp from getting too hot but even with that if you have two six cavity aluminum molds for large bullets, say a .45 and a .44, you occasionally have to let them cool down a bit. I always just use one, as I'm casting hollowpoints and you need to keep the hollowpoint pin hot. Don
NRA Certified Metallic Cartridge Reloading Instructor
|
|
|
|
Joined: Oct 2014
Posts: 4,755
Campfire Tracker
|
Campfire Tracker
Joined: Oct 2014
Posts: 4,755 |
Do you fellows always cast with one mold or more?
I always use two in rotation, while one is cooling and the sprue hardening I'm filling the other one. That generally seems to keep the mold temp from getting too hot but even with that if you have two six cavity aluminum molds for large bullets, say a .45 and a .44, you occasionally have to let them cool down a bit. I just cast with one usually, because swapping molds slows me down. I tend to cast quickly though, and quench the mold every 5-10 casts to keep it cool enough.
|
|
|
|
Joined: Jun 2007
Posts: 22,009 Likes: 3
Campfire Ranger
|
Campfire Ranger
Joined: Jun 2007
Posts: 22,009 Likes: 3 |
I usually always cast with two, sometimes 3 of the same material, block size and nominal bullet size.
A hotplate can be used if needed for a mould out of geat sequence.
Really small bullets/moulds like aluminum 22s may need solo attention, but the hotplate can allow even them maintain a consistent cycle to empty the potm
|
|
|
|
562 members (222Sako, 204guy, 10gaugemag, 10gaugeman, 06hunter59, 1beaver_shooter, 55 invisible),
13,874
guests, and
1,023
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
Forums81
Topics1,195,133
Posts18,542,421
Members74,057
|
Most Online21,066 May 26th, 2024
|
|
|
|
|