6mm/22-250 built on an early 7-digit Rem 700 SA CM receiver. Receiver face and bolt face were squared up. Barrel is Pac-Nor Stainless Match 5-groove 1-9" twist Rem Factory Mountain Rifle dupe cut at 22". Protected crown. All receiver and barrel work done by
Ray Montgomery out of Grand Junction, CO. His crowns are a work of art, for sure. Includes all parts except stock, including aluminum ADL T/G and X-Mark trigger (NOT X-Mark Pro).
Bolt was sent to Kampfeld to remove jeweling, Ti-flute, and install a hunter smooth knob ($175). Bolt shroud is PT&G aluminum.
I will also include a set of Redding dies. The FL die set now is $177 (in stock) from Grafs and $200 special order from MidwayUSA.
My son used this rifle to deer hunt, and I was loading 85 TSX at about 2,900 fps. Excellent round, and 22-250 brass is easy to get.
$975 shipped from individual (non-licensee) to FFL lower 48.