i finally located a source of starline brass for my new glock earlier this week. I ended up getting some remington 155grain jcp's, some xtp 180grainers, and berry's plated 180grain hp's. Using aa no 7, the 155's were at 11.5, the xtp's at 10.5 and the berry's at 9.5. At first chance i am going to run them through a chrony. Both with the factory barrel, then the kkm six inch barrel. What i found interesting in referencing any number or reloading guides, were the anemic loads presented that made me think .40s&w.
I finally went back to an older accurate loading manual to do the above loads. I also want to find/order some fmj 200grainers for 10mm. the other thing I think i need to do given the velocities is some penetration type testing to see if various bullets actually holt together. that's another part of reloading thats interesting these days. had plenty of other powders including aa5, 9, etc. but wanted 7. had to look all over the valley to find a pound of it.
Last edited by RoninPhx; 01/30/10.
