Home Forums Gear Free Classifieds Cut-Rifled Stainless 6.5mm 1/8" Sporter-Weight Barrel Blanks

New, never taken out of the shipping sleeve 27" Brux barrel blanks. Made a duplicate order so I have a couple of these to sell.

6.5mm bore
1-in-8" twist
#4 Sporter Contour (Same as #3 from Bartlein)
Cut-rifled

Blank measures 0.660" near muzzle. Should finish out nearly identical to a factory Remington sporter barrel.

Brux makes some of the finest barrels on the market with numerous championships and records in several shooting sports. My last Brux 6.5mm tube was as accurate as any barrel I've ever seen. During load development I had five different sub-half-moa groups (5 shots per) with five different powder charges on one target. Hard to top that!

http://www.bruxbarrels.com/gpage2.html

http://www.6mmbr.com/barrels.html (recommended)

http://weww.snipershide.com/forum/ubbthreads.php?ubb=showflat&Number=2487426 (Discussion & reviews)

To your door in a few days for $300 ea.

email me at urbancarbineyahoo.com

Thanks,

Kyle

TTT. Will get pics asap.

Kyle, what contour and caliber was that bbl you shot?

BTW, what groove config and do you have a weight on your blank?

Thanks.

Also shank length? Thanks.

My previous Brux was a #5 (light target or light palma, I can't recall). It was just stupid accurate. At 26" it gave 2850fps with RE17 and no pressure at all. I actually went up over 2900 fps without pressure, but accuracy wasn't quite as good (a mere 3/4 MOA ).

Brux contour chart:



These blanks as is; un-chambered, un-threaded, full shank, and a full 27" long weigh 4 lbs.

Once chambered, cut, threaded and shank brought down to where it should be I'd say the finished product will be between 3.0 and 3.5 lbs depending on your tastes in barrel length, shank length, etc.... This should put you on track to build a perfect 7lb sporter-weight rifle. Of course, you could always have the blank fluted and save another 1/2 lb or so if you wanted.

It is killing me to not build a 6.5 WSM or 6.5 SAUM on one of these.....

Kyle

Forgot to add....

I'm building a .260 on one of these with a 1" shank length. Blank as shipped has a 2.75" shank length to allow you plenty of options.

Thanks



Might take Remmy 700 short actions on trade, too.

This is a good deal and wish I was reloaded on cash to snap one up.

Certainly willing to entertain trade offers. You never know.....

Favorites:

.260 Rem
.300 WSM
.350 Rem Mag
EDGE stocks
SLR cameras, lenses, speedlites, etc.
Manfroto tripods

Who knows what else...

I will take one. PM sent

27" unchambered blank shown laid on an LVSF stock

.

If I did not have 2 Bartleins JUST like this, I'd take one. Someone needs a good 6.5mm

I will take one if you still have available. PM sent

Thanks. Still have extras.

TTT

.

.

.

Couple left.

.