tough one to let go but I have other irons in the fire.
Tikka T3 Lite ss, factory barrel and action
aftermarket trigger spring
LRI fluted bolt
aftermarket bottom metal
Richards microfit Rollover in AAA claro walnut
action and bottom metal bedded using jb weld (my first bedding job)
Stock was shaped and finished by me (my first attempt so go easy on me)
sanded down to 800 grit
put on many coats of arrow oil, some coats with saw dust filler
sanded back down and then used Tru-Oil, probably 20 coats total
the tip was cut down for my liking and not knowing they use a dowel to mate the
rosewood tip with the walnut stock, I exposed that dowel. I fixed it the best
I could by drilling out a small hole and cutting a plug from the section I cut
off and matching the grain as best i could. it didn't turn out too bad imo but
not perfect (see picture). I haven't gotten around to installing sling studs
on it yet
total round count is unknown but not many as I bought the barreled action used and
previous owner didn't have a lot on it but didn't say a number. I've probably
put 20 or so thru it only. I have dies and probably 5 boxes of factory norma
140 gr ammo available to buyer first.
Scope mounted is NOT included; but could include a Nikon ProStaff5 4.5-18x40 for a little more money
will separate barreled action if stock sells first
$1250 and I'll split shipping to your FFL (rifle only)
https://www.24hourcampfire.com/ubbthreads/ubbthreads.php/galleries/19396847#Post19396847
