After doing the math I found there was no sight of the correct height to get me where I needed to be for proper zero while keeping the receiver sight sitting low. I ordered a Skinner Partridge that was .500" tall and will file it down to correct height once I get load development done with this rifle. I had to take .013 off the dovetail with a triangular file to get it to fit:
[Linked Image]

Old sight punched out with Skinner punch (well made if you need a sight punch that is brass):
[Linked Image]

My range is shut down for maintenance today so I hope to get a chance to shoot it tomorrow or this weekend because I will be gone for another week starting Monday.