Is that pullet like a chicken? "Chuckle". A 10EE measures 27" from a faceplate to the end of the spindle. If you manufactured a cathead for both ends of the spindle, I believe would put a 28" blank flush on both ends if you were lucky. A 1.375 barrel blank will fit in the spindle. I believe the #2 Morse is the tailstock taper, it ain't the taper in the headstock as a 5C collet wouldn't work. All 10EE will use the 5C collets.
Pullit, I'm just kidding about the chicken.
Last edited by butchlambert1; 09/17/16.
