Here's my question now. How in the world do you disassemble the gun or remove the bolt? There are two bolts holding the stock to the action, in the standard location you would expect. Only issue is, they are rounded off and cannot be turned with a flat head screwdriver or allen wrench. Any ideas?
Congratulations! The two stock action screws OEM take a 5mm Allen wench hopefully they are not messed up.
On the bolt to remove, 1st make a mental note of the position of the bolt handle when closed. Now pull back on the bolt to the rear. Use a 4mm Allen wrench and take out the 4mm cap screw at the top of the bolt handle were it turns 90 degrees. With the bolt handle removed you can now remove the bolt for cleaning the barrel. Careful not to play with the bolt and it will just slide back in and you can re attach the bolt handle.
Than to assemble slide bolt back in. Than reattach bolt handle. Make sure you index bolt handle correctly (its kind of on some cam lobes) and just snug up the 4mm Allen making sure its seated correctly on the cam lobes when doing so.
