I use the RCBS Luber/Sizer. The boolit is long enough that I have to slip "bullet ejection plate" out of the way of the "threaded rod" so I can get the boolit in and out of the sizer die mouth. Is this typical?
Alan
Yes, it is, all the way through the
downstroke, with the "threaded rod" backed down as far as it will go when trying to size down the nose. It should go so far that the base/gas check enters the top of the die.
Just be sure the "ejection plate" isn't so loose on the
upstroke it slips off of the rod (liftout plug).
The nutz on the two rods can be adjusted to do this.
Its best to seat the gas checks and lube before changing your adjustments to get the extra travel needed when nose sizing.
