I figure RWE can handle that. He's bushed pins before on the double he built.
I bushed a set on the 30-30 SxS build - you know, the one I blew up the stock on before I bushed the strikers...
But that was by hand, and strictly another example of "I'm too stubborn to be economical" and afterwards it it hit the official "Don't want to do that again without power tools" list.
It's an adequate but ugly job
Didn't know about the detonation.
Scratch that idea.
Sell the roller down the road, cut your losses, and move on?
so you know - it blew up BEFORE I did the strikers.
Shooting fine since. Still need to finish up the quarter rib and regulate it.
As for the ROB - Sell it?
Pshhhh
All this needs is a rebarrel, extractor, and bushing the firing pin from this 0.102" diameter one, correct?
Plenty of walnut here to put new furniture on.
