I sold a few chokes I didn't want anymore. Decided to use some of the funds to buy a couple Trulock Chokes. They seem to get good reviews.
I bought a Trulock Longbeard XR .665 turkey choke. And a Trulock Deerstroyer (lame name) .710 buckshot choke. Both in Invector Plus. Should have them in a few days.
I'm particularly looking forward to trying the buckshot choke. I've yet to come across an aftermarket extended buckshot choke that outperforms a standard Imroved Modified or Full choke. My Carlsons Buckshot Choke equals them, but doesn't exceed. If the UToob reviews on the Trulock Boar Buster (same as the Deerstroyer) are true, they hold a pretty dang good pattern at 40 yards.
Anyone using Trulocks? Don't hear much about them.
When I shot the Federal Heviweight #7 shot, Turelock built a choke that did very well with them. George was a true gentleman..
His sons appear to be, as well. I have to admit, I wasn't altogether committed to trying any new choke tubes. But the gentlemanly demeanor of the sons really was a factor in deciding to give them a try.
What I didn't know until I started researching Trulock was that Trulock makes some chokes for other names. For instance, Trulock makes the Primos Jellyhead chokes.
That buckshot choke is .710 (.030). Looking forward to trying it. The same choke is also labeled "Boar Blaster." From what I understand, the "Deerstroyer" and the "Boar Blaster" are identical chokes. Both are .030 chokes. The Boar Blaster gets pretty good reviews on UToob, and seems to produce a pretty good patter with smaller count loads. I have some Remington 3" 000 loads I am hoping will pattern well through it.
The Long Beard choke has a longer parallel section than my Carlsons chokes. I tend to think a longer parallel section makes for tighter patterns. Not really sure why I think that but it seems right to me.
They offer both that I saw, ported or non-ported. I also thought it I interesting that they build choke tubes for specific shells. As far as ported or non-ported, doesn't matter, I'll use either. But did note that Federal used to recommend non-ported with their flite control wads. Tubes I use now are non-ported.
It isn't what happens to you that defines you, it's what you DO about what happens to you that defines you!
^^^^ Trulock (George Turlock) has been my main go-to for years, outside of a few niche folks for a tube here or there. They’re always quality, great to deal with, and are a consistent good bet for starting pattern work. Buy Trulock over anything Carlson, all day long.
Found a NOS Trulock 12ga .680" extended turkey tube for the Mossberg 835 I recently picked up for $20. After reading this, felt it was well worth the expense to try it.
It isn't what happens to you that defines you, it's what you DO about what happens to you that defines you!
I think the .835 has a bore diameter of .777, which is actually bigger than a 10 gauge at .775. Choking that down to .680 (.097) is quite a step down.
Those and Browning overbore stuff have barrels that gradually come back to a nominal size for their choke system. I’m also thinking those #s are for maximum bore size. Not sure what ‘cylinder’ is at the muzzle on the 835, but it’s probably closer to 12ga than 10ga.
SRM Terror tubes use some type of geometry to go really tight… down to .655, and they work great on Invector Plus and other systems.