I bought a set in Cerekote for a build - data point of one set.
Cerekote seems pretty thin for what it is supposed to be, but it was even, and fully covered.
I'd like to check the alloy for actual hardness, I know what it's supposed to be from the specs.
Hammer pivot pin hole was pucker tight, I had to clean it a bit to get the pins in. Seemed straight, just tight.
Roll pin hole for the bolt stop was tight, standard roll pin went in, but it was a pain to get started - to the point I thought I had the wrong pin.
Last edited by AH64guy; 07/12/17.
